Unified CVP - IOS - Some interface configs do not show up when doing a "sh run"
From DocWiki
Unified CVP - IOS - Some interface configs do not show up when doing a "sh run"
| Problem Summary | Unified CVP - IOS - When doing a "sh run" command to see if some of the recommended settings on a gateway interface are set, it's unclear if those settings are in place or not. For example, the following settings are recommended based on the CVP Config and Admin guide:
ip route-cache same-interface ip route-cache cef ip route-cache ip mroute-cache no cdp enable But when a "sh run" commmand is done, only the following may show up: interface GigabitEthernet0/0 ip address 192.168.150.176 255.255.255.0 ip route-cache same-interface duplex auto speed auto negotiation auto no cdp enable From this it looks like the: ip route-cache cef ip route-cache ip mroute-cache settings are not enabled. But in reality they are enabled. If one does an explicit "no ip route-cache cef", "no ip route-cache", "no ip mroute-cache" and does a "sh run" after that, these will appear as : interface GigabitEthernet0/0 ip address 192.168.150.176 255.255.255.0 ip route-cache same-interface no ip route-cache cef no ip route-cache no ip mroute-cache duplex auto speed auto negotiation auto no cdp enable Hence, the purpose of this note is to clarify that unless one explicitly sees those settings with a "no" infront of them then it means they are on. |
|---|---|
| Error Message | N/A |
| Possible Cause | N/A |
| Recommended Action | Be aware of this as initially it looks like the recommended settings are not set when a "sh run" is done. |
| Release | CVP 8.0(1) |
| Associated CDETS # | None |
