User contributions
From DocWiki
- 07:49, 25 November 2010 (diff | hist) N In HAoWAN setup, no relevant message displayed after data check or resync, if ports not created for any of the nodes for a Call Control Group (New page: {| border="1" |- ! '''Problem Summary''' | In HAoWAN setup if a Call Control Group doesn't have ports for any of the nodes in UCCX, Data Check or Resync result doesn't show any relevant me...)
- 07:22, 25 November 2010 (diff | hist) N Data Check Shows Mismatch for Route Partition also, When CTI Line(s) are Deleted in Cisco Unified CM
- 07:18, 25 November 2010 (diff | hist) N User Data Resync does not Show Results Properly if User Name has 1 or 2 (New page: {| border="1" |- ! '''Problem Summary''' | Consider telephony user with _1 or _2 in the User Prefix, Eg: jtapi_150 or jtapi_250. Perform Data check or data Resync for telephony User , the...)
- 06:37, 25 November 2010 (diff | hist) N Device Association Status for Call Control Groups/Triggers Shows User Does Not Exist in Data Resync Results
- 05:27, 25 November 2010 (diff | hist) N Data Resync Result Page Displays Mismatch Detected Message for Attributes Even Though Inconsistencies are Corrected (New page: {| border="1" |- ! '''Problem Summary''' | After performing Data Resync, result page display “Mismatch Detected” message for attributes even though inconsistencies are corrected. |- !...)
- 05:10, 25 November 2010 (diff | hist) N Data Resync Result Page Still Shows Red X Eventhough All Inconsistencies are Corrected (New page: {| border="1" |- ! '''Problem Summary''' | After performing Data Resync, result page still shows “red cross” even though all inconsistencies are corrected. |- ! '''Error Message''' | N...)
- 04:50, 25 November 2010 (diff | hist) N Turning on traces for Data Synchronization
- 13:23, 8 January 2010 (diff | hist) N User Authentication error during CUCM configuration
