ONS SDH TL1 Command Guide R8.5.1 -- RMV Commands
From DocWiki
This chapter provides remove (RMV) commands for the Cisco ONS 15454 SDH and Cisco ONS 15600 SDH.
Contents |
RMV-<MOD2>
The Remove 10GFC, 10GIGE, 1GFC, 1GFICON, 2GFC, 2GFICON, CLNT, D1VIDEO, DS3I, DV6000, E1, E3, E4, ESCON, ETRCLO, ETH, FSTE, G1000, GFPOS, GIGE, HDTV, ISC1, ILK, ISCCOMPAT, ISC3PEER2R, ISC3PEER1G, ISC3PEER2G, STM4, STM64, STM1, STM16, OCH, OMS, OTS, POS, STM1E, VC3, VC44C, VC38C, VC464C, VC48C, STS36C, VC4, VC416C, VC42C, VC43C, or VC12 (RMV-<MOD2>) command removes a facility from service. See Table 27-1 for supported modifiers by platform.
Usage Guidelines
None
Category
Ports
Security
Maintenance
Input Format
RMV-<MOD2>:[<TID>]:<AID>:<CTAG>[::];
Input Example
RMV-E1:CISCO:FAC-1-1:1;
Input Parameters
|
<AID> |
Access identifier from the ALL. |
RMV-EQPT
The Remove Equipment (RMV-EQPT) command removes equipment from the In Service state and places it into the Maintenance state.
Usage Guidelines
This command is applicable only to equipment that is in transition from the In-Service state to the Maintenance state.
Category
Equipment
Security
Maintenance
Input Format
RMV-EQPT:[<TID>]:<AID>:<CTAG>[::];
Input Example
RMV-EQPT:CISCO:SLOT-1:1;
Input Parameters
|
<AID> |
Access identifier from the EQPT. |
