How to find the Baud Rate, Parity, Stop Bits, and Data Bits used by the interface/line

From DocWiki

Jump to: navigation, search

To find the baud rate, parity, stop bits, and data bits used by the interface/line, enter the show running-config command and check the line configurations. You can also use the show line number command, as shown in the following example:

Router# show line 0/1/3

  Tty Line Typ     Tx/Rx    A Modem  Roty AccO AccI  Uses  Noise Overruns  Int
 0/1/3   21 TTY   9600/9600  -    -      -    -    -     0      0    0/0    Se0/1/3

Line 0/1/3, Location: "", Type: "" Length: 24 lines, Width: 80 columns Baud rate (TX/RX) is 9600/9600, no parity, 2 stopbits, 8 databits Status: Ready Capabilities: none Modem state: Ready Group codes: 0 Modem hardware state: noCTS DSR noDTR noRTS Special Chars: Escape Hold Stop Start Disconnect Activation

               ^^x    none   -     -       none         

Timeouts: Idle EXEC Idle Session Modem Answer Session Dispatch

              00:10:00        never                        none     not set
                           Idle Session Disconnect Warning
                             never 
                           Login-sequence User Response
                            00:00:30
                           Autoselect Initial Wait
                             not set 
  Tty Line Typ     Tx/Rx    A Modem  Roty AccO AccI  Uses  Noise Overruns  Int

Modem type is unknown. Session limit is not set. Time since activation: never Editing is enabled. History is enabled, history size is 20. DNS resolution in show commands is enabled Full user help is disabled Allowed input transports are none. Allowed output transports are lat pad telnet rlogin lapb-ta mop v120 ssh. Preferred transport is lat. No output characters are padded No special data dispatching characters Router#

Rating: 0.0/5 (0 votes cast)

Personal tools