Cisco Unity Configuration
|Cisco Unity Configuration|
This topic provides a reference configuration for Cisco Unity within a Cisco Unified Communications deployment. The information is based primarily on testing performed during Cisco Unified Communications Release 8.0(2) system testing. This topic does not contain detailed step-by-step procedures; instead, for or detailed information about installing, configuring, and administering Cisco Unity, refer to the Cisco Unity documentation listed in Related Documentation section.
This component was tested as part of the system-wide testing of IP telephony functionality for Cisco Unified Communications Release 8.0(2) . For general information about the tested functionality in this system release, see the System Release Notes for IP Telephony: Unified Communications System, Release 8.0(2)
During Cisco Unified Communications Release 8.0(2) testing, this component was installed and tested as shown in the Figure.
- Unity Logical Diagram
For more information on other site models, see Tested Deployments and Site Models.
For complete details on how a representative Cisco Unity was configured during Cisco Unified Communications Release 8.0(2) testing, see the product documentation available in the Related Documentation section.
For related information about Cisco Unity, see the documents listed in Table.