Cisco Unified Presence, Release 7.x -- set network nic CLI Command

From DocWiki

Jump to: navigation, search

Main page: Cisco Unified Presence, Release 7.x

Contents

Previous Topic

This command sets the properties of the Ethernet Interface 0. You cannot configure Ethernet interface 1.


Command Syntax

set network nic eth0 [auto en | dis] [speed 10 | 100] [duplex half | full]


Parameters
  • eth0 specifies Ethernet interface 0.
  • auto specifies whether auto negotiation is enabled or disabled.
  • speed specifies whether the speed of the Ethernet connection: 10 or 100 Mbps.
  • duplex specifies half-duplex or full-duplex.


Usage Guidelines

The system asks whether you want to continue to execute this command.

Note: You can enable only one active NIC at a time.

Caution! If you continue, this command causes a temporary loss of network connections while the NIC is reset.

Requirements

Command privilege level: 1

Allowed during upgrade: No

Rating: 0.0/5 (0 votes cast)

Personal tools