Cisco Unified Presence, Release 7.x -- set network dhcp CLI Command

From DocWiki

Jump to: navigation, search

Main page: Cisco Unified Presence, Release 7.x

Contents

Previous Topic

This command enables or disables DHCP for Ethernet interface 0. You cannot configure Ethernet interface 1.


Command Syntax

set network dhcp eth0 {enable | disable}


Parameters
  • eth0 specifies Ethernet interface 0.


Usage Guidelines

The system asks whether you want to continue to execute this command.

Caution! If you continue, this command causes the system to restart. Cisco also recommends that you restart all nodes whenever any IP address is changed.


Requirements

Command privilege level: 1

Allowed during upgrade: No

Rating: 0.0/5 (0 votes cast)

Personal tools