Cisco Unified MeetingPlace, Release 7.0 -- Troubleshooting Failover for the Cisco Unified MeetingPlace Application Server

From DocWiki

Jump to: navigation, search

Main page: Cisco Unified MeetingPlace, Release 7.0

Up one level: Troubleshooting


Failover Replication Fails After Adding New Node 1

Problem: As part of the failover configuration between two Application Servers, user switched on replication with sync via mp_replication switchON command. The replication failed.


Possible Cause: A table is locking due to the processes on an active server. Both servers must be in standby mode before attempting to synchronize them.


Solution: Run the mp_replication switchON with sync command again.

Rating: 0.0/5 (0 votes cast)

Personal tools