Cisco Unified MeetingPlace, Release 7.0 -- Adding an Audio Blade to Cisco Unified MeetingPlace

From DocWiki

Jump to: navigation, search

Main page: Cisco Unified MeetingPlace, Release 7.0



The following are the default values for new Audio Blades:

Parameter Default

Name

--

IP address

--

Admin user name

Note: This is the only user who can access the Application Server.

admin

Note: Cannot be changed.

Admin user password

password

SNMP read community name

RVGET2

SNMP write community name

RVSET2


Note: Once an Application Server is configured with the credentials for an Audio Blade, that Application Server will attempt to control that Audio Blade even if the Audio Blade is attached to a different Application Server. This can result in the two systems fighting for control. To avoid this problem, it is best to use a different set of Audio Blade passwords and SNMP community names with each Application Server.


Procedure
  1. Log in to the Cisco Unified Media Server Administration. See Logging in to the Media Server Administration.
  2. Select Resource Management > MCU from the left panel.
  3. Click Add.
  4. Enter a name for the Audio Blade, the IP address, and login password for the admin user.
  5. Enter the SNMP community names.
    Note: If the Audio Blade has factory-set values for the password or SNMP community names, you can enter new values here and they will overwrite the factory-set values. If the Audio Blade has previously-set values for the password or SNMP community names, you must enter those values.
  6. Click OK.
  7. Repeat steps 3 to 6 until all the Audio Blades have been added.


Related Topics

Rating: 0.0/5 (0 votes cast)

Personal tools