Cisco Unified MeetingPlace, Release 7.0 -- About Front Panel LED Issues

From DocWiki

Jump to: navigation, search

Main page: Cisco Unified MeetingPlace, Release 7.0

Up one page: Installation



The following table describes what to do if the LEDs on the front panel of the Cisco Unified MeetingPlace 3500 Series Media Server are off at all times, including during the power off and power on cycle.


Table: Resolving Front Panel LED Issues
Possible Causes Verification Steps

Power supply problem

  • Make sure that the power supply LED is green.
  • Check the AC cable and fuse.

The blades are not inserted correctly in the Cisco Unified MeetingPlace 3500 Series Media Server chassis, or a back plane pin is bent.

  • Open the telecom latch screws and extract the blade from its slot.
  • Verify that there are no bent pins on the back plane (using a flashlight, if necessary).
  • Re-insert the blade carefully closing the latches.

Rating: 0.0/5 (0 votes cast)

Retrieved from "http://docwiki.cisco.com/wiki/Cisco_Unified_MeetingPlace,_Release_7.0_--_About_Front_Panel_LED_Issues"
Personal tools