Dosproul: 1 revision

2012-09-12T18:55:17Z

1 revision

← Older revision

Revision as of 18:55, 12 September 2012

Tataj at 13:54, 12 September 2012

2012-09-12T13:54:33Z

New page

<table border="1" cellpadding="3" cellspacing="0">
<tr>
<td> '''Problem Summary''' </td>
<td>
You place a test call and immediately receive a '''busy signal'''
</td>
</tr> <tr>
<td> '''Error Message''' </td>
<td>
NA
</td>
</tr> <tr>
<td> '''Possible Cause''' </td>
<td>
NA
</td>
</tr> <tr>
<td> '''Recommended Action''' </td>
<td>
Check the following:
* Try pinging or Telnet to the voice gateway to be sure it is up.
* Use dir to examine the files on the gateway and be sure you transferred:CVPSelfService.tcl
*: Refer to Transfer Bootstrap and .WAV Files to the Gateway.
* A busy signal is the response on a POTS phone if you dial a number that is not configured in the exercise.
</td>
</tr> <tr>
<td> '''Release''' </td>
<td>
NA
</td>
</tr> <tr>
<td> '''Associated CDETS #''' </td>
<td>
None.
</td></tr></table>

'''Back:''' [[Troubleshooting Tips for Getting Started with CVP]]

You place a test call and immediately receive a busy signal - Revision history

Dosproul: 1 revision

Tataj at 13:54, 12 September 2012