Unified SIP Proxy - Multiple Interfaces Configuration
Here is a working interface configuration (router side) that the module is able to boot up with:
interface Loopback1 description CUSP Enterprise SIP Network ip address 10.15.211.2 255.255.255.252 ! interface Loopback2 description CUSP CUBE SIP Network ip address 10.15.212.2 255.255.255.252 ! interface Integrated-Service-Engine1/0 ip address 10.15.210.2 255.255.255.252 service-module ip address 10.15.210.1 255.255.255.252 service-module ip default-gateway 10.15.210.2 no keepalive ! interface Integrated-Service-Engine1/0.1 ! interface Integrated-Service-Engine1/0.11 encapsulation dot1Q 11 ip unnumbered Loopback1 ! interface Integrated-Service-Engine1/0.12 encapsulation dot1Q 12 ip unnumbered Loopback2 ! ip route 10.15.210.1 255.255.255.255 Integrated-Service-Engine1/0 ip route 10.15.211.1 255.255.255.255 Integrated-Service-Engine1/0.11 ip route 10.15.212.1 255.255.255.255 Integrated-Service-Engine1/0.12 !
Regarding the configuration documented on CCO, the encapsulation dot1Q 1 native (or any VLAN with the keyword 'native') on the subinterfaces isn't allowed because the native VLAN traffic doesn't get its frames tagged, and tagging is the mechanism whereby IOS correlates the traffic to the NME-522 for any interfaces besides the service-module ip interface). While not actually required for the host validation, the static routes have to exist to get traffic to CUSP over the router's backplane.
We're not done yet! Once the router knows how to get the traffic to the NME, the NME itself has to know to be listening on said interfaces. Here's the matching configuration for the NME:
interface GigabitEthernet 0.1 end interface
interface GigabitEthernet 0.11 ip address 10.15.211.1 255.255.255.252 end interface
interface GigabitEthernet 0.12 ip address 10.15.212.1 255.255.255.252 end interface
interface GigabitEthernet 0.13 ip address 10.15.213.1 255.255.255.252 end interface
At this point you should be able to ping each of these IP's from your network. Note: the default gateway for all traffic is still the service-module ip default-gateway. Without the NME side configuration, CUSP will not allow you to configure sip listen for those IP addresses.