Unified SIP Proxy - Multiple Interfaces Configuration

From DocWiki

Revision as of 19:11, 3 November 2009 by Mbynum (Talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Here is a working interface configuration (router side) that the module is able to boot up with:

interface Loopback1

description CUSP Enterprise SIP Network
ip address

! interface Loopback2

description CUSP CUBE SIP Network
ip address

! interface Integrated-Service-Engine1/0

ip address
service-module ip address
service-module ip default-gateway
no keepalive

! interface Integrated-Service-Engine1/0.1 ! interface Integrated-Service-Engine1/0.11

encapsulation dot1Q 11
ip unnumbered Loopback1

! interface Integrated-Service-Engine1/0.12

encapsulation dot1Q 12
ip unnumbered Loopback2

! ip route Integrated-Service-Engine1/0 ip route Integrated-Service-Engine1/0.11 ip route Integrated-Service-Engine1/0.12 ! Regarding the configuration documented on CCO, the encapsulation dot1Q 1 native (or any VLAN with the keyword 'native') on the subinterfaces isn't allowed because the native VLAN traffic doesn't get its frames tagged, and tagging is the mechanism whereby IOS correlates the traffic to the NME-522 for any interfaces besides the service-module ip interface). While not actually required for the host validation, the static routes have to exist to get traffic to CUSP over the router's backplane.

We're not done yet! Once the router knows how to get the traffic to the NME, the NME itself has to know to be listening on said interfaces. Here's the matching configuration for the NME:

interface GigabitEthernet 0.1

end interface

interface GigabitEthernet 0.11

ip address
end interface

interface GigabitEthernet 0.12

ip address
end interface

interface GigabitEthernet 0.13

ip address
end interface

At this point you should be able to ping each of these IP's from your network. Note: the default gateway for all traffic is still the service-module ip default-gateway. Without the NME side configuration, CUSP will not allow you to configure sip listen for those IP addresses.

Rating: 4.3/5 (3 votes cast)

Personal tools