Unified CVP - IOS - Some interface configs do not show up when doing a "sh run"

From DocWiki

Revision as of 19:58, 11 March 2011 by Cchetty (Talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Unified CVP - IOS - Some interface configs do not show up when doing a "sh run"

Problem Summary Unified CVP - IOS - When doing a "sh run" command to see if some of the recommended settings on a gateway interface are set, it's unclear if those settings are in place or not. For example, the following settings are recommended based on the CVP Config and Admin guide:
ip route-cache same-interface
ip route-cache cef
ip route-cache
ip mroute-cache
no cdp enable

But when a "sh run" commmand is done, only the following may show up:

interface GigabitEthernet0/0
 ip address 192.168.150.176 255.255.255.0
 ip route-cache same-interface
 duplex auto
 speed auto
 negotiation auto
 no cdp enable

From this it looks like the:

ip route-cache cef
ip route-cache
ip mroute-cache

settings are not enabled. But in reality they are enabled. If one does an explicit "no ip route-cache cef", "no ip route-cache", "no ip mroute-cache" and does a "sh run" after that, these will appear as :

interface GigabitEthernet0/0
 ip address 192.168.150.176 255.255.255.0
 ip route-cache same-interface
 no ip route-cache cef
 no ip route-cache
 no ip mroute-cache
 duplex auto
 speed auto
 negotiation auto
 no cdp enable

Hence, the purpose of this note is to clarify that unless one explicitly sees those settings with a "no" infront of them then it means they are on.

Error Message N/A
Possible Cause N/A
Recommended Action Be aware of this as initially it looks like the recommended settings are not set when a "sh run" is done.
Release CVP 8.0(1)
Associated CDETS # None

Rating: 0.0/5 (0 votes cast)

Personal tools