Troubleshooting the Router
From DocWiki
(Difference between revisions)
(→Enabling Debugging on the Router) |
m (1 revision) |
Latest revision as of 17:12, 28 April 2011
To troubleshoot the router, see the following section:
Enabling Debugging on the Router
Problem: How do I enable debugging on the router?
Solution: To enable debugging on the router, follow these steps:
1. To enable debugging on the router, use the 'debug cns image all command.
2. If you are not on the console, enter the 'term mon command.
3. After the job completes, verify the file on the router by entering the dir command. The image file should display.
Category: Cisco Configuration Engine -- Troubleshooting
