Cchetty: 1 revision

2010-04-09T15:21:00Z

1 revision

← Older revision

Revision as of 15:21, 9 April 2010

Sakkumar: /* Trigger partition change causes JTAPI subsystem to go to Partial Service */

2010-01-29T06:43:41Z

Trigger partition change causes JTAPI subsystem to go to Partial Service

New page

== Trigger partition change causes JTAPI subsystem to go to Partial Service ==

{| border="1"
|-
! '''Problem Summary'''
| Changing of the partition of the Trigger/route point from Unified Communications Manager Administration causes Unified CCX CM Telephony subsystem to go to Partial Service
|-
! '''Error Message'''
| Unified CCX CM Telephony subsystem goes to Partial Service
|-
! '''Possible Cause'''
| Change of partition of route point/trigger
|-
! '''Recommended Action'''
| This is caused by the below mentioned bug. The work around is to restart the Unified CCX Engine.
|-
! '''Release'''
| Release 8.0(1) and Release 7.0(1)
|-
! '''Associated CDETS #'''
| [http://cdets.cisco.com/apps/dumpcr?content=summary&format=html&identifier=CSCtb04305 CSCtb04305]
|-
|}
[[Category:Unified CCX, Release 8.0]]
[[Category:Unified CCX, Release 7.0]]

Trigger partition change causes JTAPI subsystem to go to Partial Service - Revision history

Cchetty: 1 revision

Sakkumar: /* Trigger partition change causes JTAPI subsystem to go to Partial Service */