SAF Forwarder with L2 Adjacency Configuration Example

From DocWiki

(Difference between revisions)
Jump to: navigation, search
 
(One intermediate revision not shown)
Line 12: Line 12:
==Related show Commands==
==Related show Commands==
-
show eigrp service-family [ipv4|ipv6] neighbors
+
show eigrp service-family ipv4 neighbors
-
Example:
+
Example(s):
  [[Image:Show_eigrp_service-family_ipv4_neighbors.jpg‎]]
  [[Image:Show_eigrp_service-family_ipv4_neighbors.jpg‎]]

Latest revision as of 15:39, 7 June 2010

Contents

Introduction

This configuration example demonstrates how to configure SAF Forwarders that share a common multi-access segment.

Example

Saff l2.jpg


Related show Commands

show eigrp service-family ipv4 neighbors

Example(s):

Show eigrp service-family ipv4 neighbors.jpg

Commonly Asked Question

Q: Does SAF have to run EIGRP?

A: Although SAF requires that an EIGRP virtual-instance be configured ("SAF-fwdr" in the example above), EIGRP as a routing protocol is not required in order for SAF to operate properly. SAF is responsible for advertising services and not IP prefixes. SAF can run with any routing protocol (eg: static, RIP, EIGRP, OSPF, BGP).

Related Information

Technical Support & Documentation - Cisco Systems SAF Product Page - Cisco Systems Cisco IOS SAF Configuration Guide - Cisco Systems

Rating: 0.0/5 (0 votes cast)

Personal tools