RmCm subsystem stuck in INITIALIZING state

From DocWiki

(Difference between revisions)
Jump to: navigation, search
(→RmCm subsystem stuck in INITIALIZING state)
m (1 revision)
 

Latest revision as of 15:20, 9 April 2010

RmCm subsystem stuck in INITIALIZING state

Problem Summary RmCm subsystem stuck in INITIALIZING state.
Error Message None.
Possible Cause
  1. Jtapi Subsystem also in partial/out of service - CTI ports, RP's not properly initialized.
  2. RM-CM subsystem is unable to read any configuration information.
Recommended Action

Complete the following steps:

  1. Restart "CTI Manager" service in Call manager if JTAPI Subsystem is also in partial/out of service
  2. Goto Unified CCX Serviceability > Tools > Control Center - Network Services. Under DB Services, check whether "Cisco Unified CCX Database" is In-Service or not. If Out of Service then start it.
Release Release 8.0(1)
Associated CDETS # None.

Rating: 0.0/5 (0 votes cast)

Retrieved from "http://docwiki.cisco.com/wiki/RmCm_subsystem_stuck_in_INITIALIZING_state"
Personal tools