PPPoE Client-Server setup and configuration
This is an example of configuring PPPoE in a back-to-back scenario. The objective here is to simulate a PPPoE server (typically found on the ISP end) Client--Fa0/0----------------------------------------Fa0/0--Server In this example, we're using 2 routers connected back-to-back on their Fa0/0 ports. Here're the parameters being simulated 1. Authentication using Chap/Pap (Username: cisco, password: sisco) 2. Client being authenticated by the server (one way authentication) 3. IP address being negotiated using IPCP Here's the relevant configuration needed on the client router interface FastEthernet0/0 no ip address<nowiki><nowiki>Insert non-formatted text here</nowiki> no ip redirects no ip unreachables no ip proxy-arp ip virtual-reassembly ip tcp adjust-mss 1452 duplex auto speed auto pppoe enable pppoe-client dial-pool-number 1 !
interface Dialer1 ip address negotiated encapsulation ppp dialer pool 1 dialer-group 1 no cdp enable ppp authentication pap chap callin ppp pap sent-username cisco password sisco ppp chap hostname cisco ppp chap password sisco ! ip route 0.0.0.0 0.0.0.0 Dialer1
Here's the relevant configuration needed on the Server
username cisco password sisco ! bba-group pppoe global virtual-template 1 ! interface FastEthernet0/0 ip address 10.252.102.49 255.255.255.240 ip rip advertise 4 load-interval 30 duplex auto speed auto pppoe enable group global !
interface Virtual-Template1 mtu 1492 ip unnumbered FastEthernet0/0 peer default ip address pool pppoepool ppp authentication pap chap ! ip local pool pppoepool 10.10.10.1 10.10.10.200 !
Here's how the flow will be
1. Client negotiates PPPoE using PADo, PADi and PADr with the server, both client and server move into PPP-->LCP phase 2. Client/Server negotiate authentication, other parameters 3. Server asks the client for a username/password (using pap, as pap is configured before chap) 4. Client sends out a username/password configured in it's dialer 5. Server authenticates this username/password against its global username/password list (alternatively a AAA/Radius server) 6. Client and Server both move on to IPCP phase 7. Client sends an ip address of 0.0.0.0 (asking for an ip address from the Server) 8. Server hands out an IP address from its pool (in this case pppoepool) 9. Client/Server finish IPCP phase and the link comes up
At this time, the link should be up and able to pass traffic </nowiki>