General Troubleshooting: Error When Adding a Dial-Peer

From DocWiki

Revision as of 21:50, 14 September 2009 by Ccosenti (Talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Error When Adding a Dial-Peer

Problem Summary When adding a dial-peer, an error message is issued and the dial-peer is not added.
Error Message Could not add peer.
Possible Cause This message implies that the amount of memory required to add the dial-peer is not available.
Recommended Action Use the show memory command to verify the available free memory. If the available free memory is > 0, then the logging buffer is taking up all available memory. In this case, adjust the amount of memory used by the log buffer by changing the value of logging buffered <numeric value>. The recommended value for this setting is between 10 - 20% of the total Gateway memory.
Release Release 7.0(2)
Associated CDETS # None.

Rating: 3.5/5 (2 votes cast)

Personal tools