FACT show multicast egress ports

From DocWiki

Revision as of 21:44, 2 May 2008 by Lorlando (Talk | contribs)
Jump to: navigation, search

Note: This command is not implemented in the FACT Alpha II release.

To show the egress ports that forward multicast traffic to each specified destination port, use the show multicast egress ports command.

show multicast egress ports [chassis | chip] [to multicast-groups] [guids]

Syntax Description

chassis (Optional) Shows only switch chassis egress ports.
chip (Optional) Shows only the egress ports for each InfiniBand switch chip.
to (Optional) Identifies the destination set.
multicast-groups (Optional) Shows only the egress ports to the specified multicast groups.
guids (Optional) Shows device GUIDs.

Command Default

The default view is the chassis view. If multicast-groups is not specified, egress ports for all multicast destinations are shown.


The following is sample output from the show multicast egress ports command, and it shows the egress ports used for each multicast group:
  fact> show multicast egress ports
  MGID ff:12:40:1b:ff:ff:00:00:00:00:00:00:00:00:00:01, lid 49153:
  MGID ff:12:40:1b:ff:ff:00:00:00:00:00:00:ff:ff:ff:ff, lid 49152:
  MGID ff:18:a0:1b:00:00:00:00:00:00:05:ad:00:02:80:da, lid 49154:
  none found

Related Commands

show destinations
show egress ports
show multicast destinations
show multicast routes
show routes

Rating: 0.0/5 (0 votes cast)

Personal tools