FACT show egress ports

From DocWiki

Revision as of 21:42, 2 May 2008 (view source) Lorlando (Talk | contribs) ← Older edit		Latest revision as of 18:18, 12 June 2008 (view source) Lorlando (Talk | contribs)
Line 1:		Line 1:
-	<span style="color:red">'''Note''': This command is not implemented in the FACT Alpha II release.</span>

---

Latest revision as of 18:18, 12 June 2008

To show the egress ports that forward unicast traffic to each specified destination port, use the show egress ports command.

show egress ports [chassis | chip] [{to [hosts | switches | ports]} [guids]

Syntax Description

chassis	(Optional) Shows only switch chassis egress ports.
chip	(Optional) Shows the egress port of each InfiniBand switch chip.
to	(Optional) Identifies the destination set.
hosts	(Optional) Shows only the egress ports to the specified hosts.
switches	(Optional) Shows only the egress ports to the specified switches.
ports	(Optional) Shows only the egress ports to the specified ports.
guids	(Optional) Shows port GUIDs.

Command Default

The default view is the chassis view.

Examples

The following is sample output from the show egress ports command, and it shows all the unicast egress ports that route to host01:

  fact> show egress ports to host01
  
  
  Destination port host01/1/1, lid 792:
  egress-port
  --------------------------------
  switchA/1/3
  switchB/1/7

Related Commands

show destinations

show multicast routes

show multicast destinations

show multicast egress ports

show routes