Desktop Errors: Call Control - Revision history

Kemacdon at 14:05, 5 July 2011

2011-07-05T14:05:47Z

← Older revision		Revision as of 14:05, 5 July 2011
Line 4:		Line 4:
	\|-		\|-
	! '''Problem Summary'''		! '''Problem Summary'''
-	\| ~~Errors~~ might appear in the agent desktop for call control issues.	+	\| The following errors might appear in the agent desktop for call control issues.
	\|-		\|-
	! '''Error Message'''		! '''Error Message'''

Kemacdon at 18:45, 4 July 2011

2011-07-04T18:45:40Z

← Older revision		Revision as of 18:45, 4 July 2011
Line 23:		Line 23:
	# Avoid actions which are not allowed in a given state.		# Avoid actions which are not allowed in a given state.
	# You may need to disconnect the call and retry.		# You may need to disconnect the call and retry.
-	# Verify if your intended operation ~~has completed~~. If yes, the call appearance on the UI should be updated accordingly. If not, then try hard phone controls for the intended action. If the UI is not updated accordingly, then sign out and sign back in after you have completed your call.	+	# Verify if your intended operation is complete. If yes, the call appearance on the UI should be updated accordingly. If not, then try hard phone controls for the intended action. If the UI is not updated accordingly, then sign out and sign back in after you have completed your call.
	\|-		\|-
	! '''Release'''		! '''Release'''

Cchetty: 1 revision

2010-12-13T17:41:32Z

1 revision

← Older revision

Revision as of 17:41, 13 December 2010

Conrchan: /* Desktop Errors: Call Control */

2010-12-04T01:07:54Z

Desktop Errors: Call Control

New page

== Desktop Errors: Call Control ==

{| border="1"
|-
! '''Problem Summary'''
| Errors might appear in the agent desktop for call control issues.
|-
! '''Error Message'''
|
# Unavailable in current state.
# Error making call.
# Operation failed. Try phone controls for this action. If the problem persists, sign out and sign in again after your calls. (holding / retrieving / conferencing / transferring / ending call)

|-
! '''Possible Cause'''
|
# This means that the agent tried to take an action that is not allowed until he is in a certain state - for example, an agent cannot place a call from the READY state.
# The destination may be busy or the number may be wrong.
# There is a race condition. You already tried to perform an action on the call but the event did not come through.
|-
! '''Recommended Action'''
|
# Avoid actions which are not allowed in a given state.
# You may need to disconnect the call and retry.
# Verify if your intended operation has completed. If yes, the call appearance on the UI should be updated accordingly. If not, then try hard phone controls for the intended action. If the UI is not updated accordingly, then sign out and sign back in after you have completed your call.
|-
! '''Release'''
| Release 8.5(1)
|-
! '''Associated CDETS #'''
|None'''
|-
|}

[[Category:Cisco Finesse, Release 8.5]]