Desktop Errors: Call Control

From DocWiki

(Difference between revisions)
Jump to: navigation, search
(→Desktop Errors: Call Control)
m
 
(2 intermediate revisions not shown)
Line 4: Line 4:
|-
|-
! '''Problem Summary'''
! '''Problem Summary'''
-
| Errors might appear in the agent desktop for call control issues.
+
| The following errors might appear in the agent desktop for call control issues.
|-
|-
! '''Error Message'''
! '''Error Message'''
Line 23: Line 23:
# Avoid actions which are not allowed in a given state.
# Avoid actions which are not allowed in a given state.
# You may need to disconnect the call and retry.
# You may need to disconnect the call and retry.
-
# Verify if your intended operation has completed.  If yes, the call appearance on the UI should be updated accordingly.  If not, then try hard phone controls for the intended action. If the UI is not updated accordingly, then sign out and sign back in after you have completed your call.
+
# Verify if your intended operation is complete.  If yes, the call appearance on the UI should be updated accordingly.  If not, then try hard phone controls for the intended action. If the UI is not updated accordingly, then sign out and sign back in after you have completed your call.
|-
|-
! '''Release'''
! '''Release'''

Latest revision as of 14:05, 5 July 2011

Desktop Errors: Call Control

Problem Summary The following errors might appear in the agent desktop for call control issues.
Error Message
  1. Unavailable in current state.
  2. Error making call.
  3. Operation failed. Try phone controls for this action. If the problem persists, sign out and sign in again after your calls. (holding / retrieving / conferencing / transferring / ending call)
Possible Cause
  1. This means that the agent tried to take an action that is not allowed until he is in a certain state - for example, an agent cannot place a call from the READY state.
  2. The destination may be busy or the number may be wrong.
  3. There is a race condition. You already tried to perform an action on the call but the event did not come through.
Recommended Action
  1. Avoid actions which are not allowed in a given state.
  2. You may need to disconnect the call and retry.
  3. Verify if your intended operation is complete. If yes, the call appearance on the UI should be updated accordingly. If not, then try hard phone controls for the intended action. If the UI is not updated accordingly, then sign out and sign back in after you have completed your call.
Release Release 8.5(1)
Associated CDETS # None

Rating: 0.0/5 (0 votes cast)

Retrieved from "http://docwiki.cisco.com/wiki/Desktop_Errors:_Call_Control"
Personal tools