Desktop: Agent sign in fails after installation

From DocWiki

(Difference between revisions)
Jump to: navigation, search
m (1 revision)

Revision as of 16:30, 17 May 2012

Desktop: Agent sign in fails after installation

Problem Summary After a fresh installation of Finesse, agents cannot sign in to the desktop.
Error Message Invalid username or password. Please try again.
Possible Cause

Common issues include

  • Username or password is incorrect.
  • The Domain was not configured during installation.
  • The agent is not properly configured in Unified CCE.
  • The AWDB is not configured correctly.
  • Cisco Tomcat was not restarted after configuration.
  • The agent's device is not configured correctly in Unified CM.
Recommended Action
  • Verify that the username and password is correct.
  • Verify that a valid domain was configured during installation and that forward and reverse DNS are set up correctly. To check if DNS was configured during installation, check the install.log for the following:

    InstallWizard|USER_ACTION_BTN_PUSH: Screen = DNS Client Configuration, button pushed = No|<LVL::Info

    The preceding message indicates that DNS was not configured during the installation. If this is the case, reinstall Finesse and configure the DNS with a valid domain. For information about collecting Finesse logs, see the section "Commands Supported for Cisco Finesse" in the
    User Guide for the Cisco Finesse Administration and Serviceability Consoles.
  • Verify that the agent has been configured in Unified CCE.
  • Verify that AWDB is configured with a Windows Domain user and the SQL server is configured for Windows authentication.
  • Restart Cisco Tomcat on the primary and secondary Finesse servers.
  • Verify that the agent's device is properly configured in Unified CM and is active.
Release Release 8.5(3)
Associated CDETS # None.

Rating: 3.0/5 (1 vote cast)

Personal tools