Configuration for Fax Pass through

From DocWiki

(Difference between revisions)
Jump to: navigation, search
(New page: {{Template:Required Metadata}} ==Introduction== The following details should give you a small configuration example on how to configure Fax passthrough for an MGCP gateway which is contr...)
(Configuration)
 
(One intermediate revision not shown)
Line 10: Line 10:
   
   
==Configuration==
==Configuration==
-
 
+
<pre>
voice service voip  
voice service voip  
fax protocol none
fax protocol none
Line 22: Line 22:
mgcp package-capability rtp-package
mgcp package-capability rtp-package
mgcp fax t38 inhibit
mgcp fax t38 inhibit
 +
</pre>
==Related show Commands==
==Related show Commands==
show mgcp  displays MGCP configuration
show mgcp  displays MGCP configuration
show ccm-manager displays if the gateway is registered with the call manager or not
show ccm-manager displays if the gateway is registered with the call manager or not
 +
[[Category:Configuration Examples]]

Latest revision as of 17:24, 23 June 2010

Contents

Introduction

The following details should give you a small configuration example on how to configure Fax passthrough for an MGCP gateway which is controlled by the Call Manager.

Design

PSTN-----T1 PRI-----MGCP gateway------CM------mgcp VG224----Fax machine

Configuration

voice service voip 
fax protocol none
!
ccm-manager mgcp
no ccm-manager fax protocol cisco
!
mgcp
mgcp call-agent 10.3.222.1 service-type mgcp version 0.1
mgcp modem passthrough voip mode nse
mgcp package-capability rtp-package
mgcp fax t38 inhibit

Related show Commands

show mgcp displays MGCP configuration show ccm-manager displays if the gateway is registered with the call manager or not

Rating: 4.0/5 (2 votes cast)

Personal tools