Configuration: Configuration data is not synchronized between Primary and Secondary Servers
Configuration data is not synchronized between Primary and Secondary Servers
|Problem Summary||When Secondary Server joins Primary Server in the same cluster, configuration data is not synchronized between the two servers after all services are activated on Secondary Node.|
|Possible Cause||This happens because, when Secondary Node joins the cluster, it takes a data snapshot from Primary Node, and then sets up data replication. There is a small window between the two steps, during which data will get out of sync between the two servers.|
Run the following CLI command on Secondary Node after all services are activated, to sync up config data with Primary Node:
That command will launch Informix data repair jobs. Run the following CLI command on Secondary Node to monitor the status of the jobs:
When all status is "C" (completed), jobs have completed successfully and config data is in sync between the two nodes.
See the Installation and Admin Guide for Cisco Media Capture Platform, Chapter 8, for more information on the CLIs.
|Associated CDETS #||CSCti87080|