Configuration: Call between two RT phones is not recorded

From DocWiki

(Difference between revisions)
Jump to: navigation, search
m (1 revision)

Revision as of 18:59, 21 April 2011

Call between two RT phones is not recorded

Problem Summary When a call is established between two RT phones (89XX and 99XX family), the call is not recorded by Unified MCP.
Error Message State of the recorded conversation is ERROR.
Possible Cause When a call is established between two RT phones (89XX and 99XX family), G722 codec is negotiated for the call. If G722 is disabled using service parameters, however, the 2 RT phones negotiate iSAC codec by default (Low Loss). Cisco MediaSense does not support G722 or iSAC codecs. Consequently, the call is not recorded.
Recommended Action
  1. Make sure to set up G729 codec for both of the RT phones OR
  2. Install Unified CM 8.5(1)SU1 software update which allows you to disable iSAC codec for recording enabled devices AND disable iSAC codec for recording enabled devices using the Unified CM Administration page.
Release Release 8.5(1) and 8.5(2).
Associated CDETS # None.

Rating: 0.0/5 (0 votes cast)

Retrieved from "http://docwiki.cisco.com/wiki/Configuration:_Call_between_two_RT_phones_is_not_recorded"
Personal tools