Cisco Unified MeetingPlace Release 6.1 -- Troubleshooting the Cisco Unified MeetingPlace Audio Server System Installation

From DocWiki

Revision as of 21:29, 28 March 2011 by MeetingPlace Moderator (Talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Cisco Unified MeetingPlace Release 6.1 > Cisco Unified MeetingPlace Audio Server > Installing the hardware






Troubleshooting the Connection to the Audio Server System

If you cannot connect to the Cisco Unified MeetingPlace Audio Server system by using MeetingTime, try any or all of the following tasks:

  • Enter ping to ping a known good IP address to determine if the network can access the Cisco Unified MeetingPlace Audio Server system.
  • Confirm with the network administrator that Cisco Unified MeetingPlace has been set up in the local host file.
  • Check that you performed all the steps in the Setting Up Dial-Up Networking.
  • Check the network cabling.
  • If possible, use a PC to check the LAN connectivity.
  • Verify the network configuration by entering the net command.
  • Verify the IP address, subnet mask, and default gateway values.
  • Make sure that all cards and transition modules are seated properly.
  • Check all cables and connections.


Note: For CLI command information, see the Command-Line Interface Reference.


If these actions do not correct the problem, contact Cisco TAC. See Obtaining Support.


Troubleshooting Telephony Configuration

To Troubleshoot Telephony Configuration
  1. Check that the information you entered into MeetingTime from the Database Planning Worksheets is correct.
  2. Check all the physical connections to the Cisco Unified MeetingPlace Audio Server system.
  3. For the Cisco Unified MeetingPlace 8112, check that no LEDs are in a bad state. (See Alarm Panels for the Cisco Unified MeetingPlace 8112.)
  4. If you made any changes to the MeetingTime configuration, access the CLI and enter restart .
  5. After the Cisco Unified MeetingPlace Audio Server system comes back up, repeat the testing procedures.
    If these actions do not correct the problem, contact Cisco TAC. (See Obtaining Support.)

Rating: 0.0/5 (0 votes cast)

Personal tools