Cisco Unified MeetingPlace, Release 7.0 -- Configuring a SIP Trunk Security Profile in Cisco Unified Communications Manager for Cisco Unified MeetingPlace

From DocWiki

(Difference between revisions)
Jump to: navigation, search
m (1 revision)
(CSCsy71600, changed definition for Outgoing Transport Type)
Line 68: Line 68:
|
|
-
For reliability, we recommend that you select '''TCP''', but you may choose to use UDP instead.
+
We recommend that you select '''UDP'''.
|-
|-
|
|

Revision as of 18:46, 27 April 2009

Main page: Cisco Unified MeetingPlace, Release 7.0

Up one level: Integration




We recommend that you do the following:

  • Create a SIP trunk security profile in Cisco Unified Communications Manager specifically for Cisco Unified MeetingPlace.
  • Apply this SIP trunk security profile to SIP trunks to Cisco Unified MeetingPlace systems.


Contents

Before You Begin
  • This task applies only in Cisco Unified Communications Manager environments.
  • You perform this task in the Cisco Unified Communications Manager Administration pages. Because the pages and menus vary by release, you should check the Cisco Unified Communications Manager online help for step-by-step instructions for your specific release.


Procedure
  1. Go to http://<ccm-server>/, where <ccm-server> is the fully-qualified domain name or IP address of the Cisco Unified Communications Manager server.
  2. Log in with your Cisco Unified Communications Manager administrator username and password.
  3. Click System > Security Profile > SIP Trunk Security Profile.
  4. Click Add New.
  5. Configure fields described in Table: Fields for SIP Trunk Security Profile Configuration.


Table: Table 1 Fields for SIP Trunk Security Profile Configuration
Field Action

Name

Enter a name, such as SIP Trunk Security Profile for Cisco Unified MeetingPlace.

Device Security Mode

Select Non Secure.

Incoming Transport Type

Keep the default value of TCP+UDP.


If other values are available for this field, you may instead select the value that matches the transport setting for this Cisco Unified Communications Manager node on the SIP Configuration Page.

Outgoing Transport Type

We recommend that you select UDP.

Enable Digest Authentication

Uncheck this check box.

Enable Application Level Authorization

Uncheck this check box.

Incoming Port

Make sure that this value matches the port setting for this Cisco Unified Communications Manager node on the SIP Configuration Page.


Default: 5060


6. Click Save.


Related Topics

Rating: 5.0/5 (1 vote cast)

Personal tools