Cisco Unified CME triggers with 2811/CME router are not working
From DocWiki
(Difference between revisions)
Docwikibot (Talk | contribs) m (Bot: Adding {{Template:Required Metadata}}) |
|||
| Line 1: | Line 1: | ||
| + | {{Template:Required Metadata}} | ||
== Cisco Unified CME triggers with 2811/CME router are not working == | == Cisco Unified CME triggers with 2811/CME router are not working == | ||
| Line 33: | Line 34: | ||
[[Category:Unified CCX, Release 7.0]] | [[Category:Unified CCX, Release 7.0]] | ||
| - | |||
Revision as of 18:23, 18 December 2009
Cisco Unified CME triggers with 2811/CME router are not working
| Problem Summary | Cisco Unified CME triggers with 2811/CME router are not working. The integration of Cisco Unified CME with Cisco Unified CCX is correct, and there are SIP messages in the Cisco Unified CCX and Cisco Unified CME debug files. The call is offered to the Cisco Unified CCX route point but the Cisco Unified CCX application is not triggered. |
|---|---|
| Error Message | None. |
| Possible Cause | When the caller dials the trigger directory number from the phone, the call goes through but application does not get triggered and the call hangs. This could be due to the Cisco Unified CME configuration, which is as follows:
Cisco Unified CME sends Invite, but does not send OfferedEvent, so UCCX JASMIN does not report the incoming call to the SIP subsystem. Therefore, the call hangs. |
| Recommended Action |
Modify the Cisco Unified CME configuration as follows:
|
| Release | Release 7.0(1) |
| Associated CDETS # | None. |
