Cisco MDS SanOS Troubleshooting Guide -- Troubleshooting N-Port Virtualization

From DocWiki

Revision as of 10:48, 26 July 2010 by Pravraj (Talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This section describes how to identify and resolve problems that can occur with N-Port virtualization.

Contents

Overview

N-Port virtualization (NPV) reduces the number of Fibre Channel domain IDs in SANs. Switches operating in the NPV mode do not join a fabric; rather, they pass traffic between NPV core switch links and end-devices, which eliminates the domain IDs for these edge switches.


Note Note: NPV is available only for the following Cisco MDS 9000 switches: the Cisco MDS 9124 Multilayer Fabric Switch, the Cisco MDS 9134 Fabric Switch, the Cisco Fabric Switch for HP c-Class BladeSystem and the Cisco Fabric Switch for IBM BladeCenter.

NPV makes a Fabric or Blade switch appear as a host to the core Fibre Channel switch, and as a Fibre Channel switch to the servers in the Fabric or Blade switch. NPV aggregates multiple locally-connected N-ports into one or more external NP links, thereby sharing the domain ID of the NPV core switch among multiple NPV switches. NPV also allows multiple devices to attach to same port on the NPV core switch.

NPV makes use of N port identifier virtualization (NPIV) to get multiple FCIDs allocated from the core switch on the NP-port.

A switch is in NPV mode after a user has enabled NPV and the switch has successfully rebooted. NPV mode applies to an entire switch. All end devices connected to a switch that is in NPV mode must log in as an N-port to utilize this feature (loop-attached devices are not supported). All links from the edge switches (in NPV mode) to the NPV core switches are established as NP-ports. NPIV is used by the switches in NPV mode to log in to multiple end-devices that share a link to the NPV core switch.

For a complete description of NPV, refer to the Cisco MDS 9000 Family CLI Configuration Guide.

Initial Troubleshooting Checklist

Troubleshooting an NPV problem involves gathering information about the switch configuration and connectivity of individual devices and the entire SAN fabric. Begin your troubleshooting activity as follows:

Checklist

Check off

Verify that the NPV core switch supports NPIV and that NPIV is enabled.

Verify that NPV is enabled on the NPV device.

Verify that the ports are properly connected.

For all NPV core switch links, ensure that the port mode on the NPV device is NP Port, and ensure that the port mode on the NPV core switch is F Port.

Ensure that the VSAN values configured on both sides of NPV core switch link are the same.

For all the device links, ensure that the port mode on the NPV device is F port.

Ensure that the VSAN value configured on the device links is correct.

Verify the status of servers and external interfaces, using the show npv status command.

Limitations and Restrictions

Common CLI Commands for NPV

Common Problems with NPV

Moving the Login of an End Device

NPIV Is Not Enabled

VSAN Mismatches

Core NPV Device Is Not a Switch

NPV Core Switch Port Is Down

Server Interface is Down

Waiting on FLOGI from the Server or Target

Waiting on External Link to Come Up

Rating: 5.0/5 (3 votes cast)

Personal tools