Cisco MDS SanOS Troubleshooting Guide -- Managing Storage Services Modules

From DocWiki

(Difference between revisions)
Jump to: navigation, search
(SSM Overview)
(SSM Overview)
Line 50: Line 50:
<table border="1" cellpadding="3" cellspacing="0" width="80%" bordercolor="#808080">
<table border="1" cellpadding="3" cellspacing="0" width="80%" bordercolor="#808080">
   <tr align="left" valign="bottom">
   <tr align="left" valign="bottom">
-
<th scope="col" colspan="1" rowspan="2">Cisco MDS SAN-OS Release</th>
+
<th>Cisco MDS SAN-OS Release</th>
-
<th scope="col" colspan="1" rowspan="2">Traffic Type</th>
+
<th>Traffic Type</th>
-
<th scope="col" colspan="1" rowspan="2">Disrupts Traffic?</th>
+
<th>Disrupts Traffic?</th>
</tr>
</tr>
   <tr align="left" valign="top"><td>
   <tr align="left" valign="top"><td>

Revision as of 10:38, 15 July 2010

This chapter describes how to manage the Storage Services Module (SSM) and provides information about SSI images.

Contents



SSM Overview

The 32-port Fibre Channel Storage Services Module (SSM) for the Cisco MDS 9000 Family supports up to 32 Fibre Channel ports and provides distributed intelligent storage services.

Note Note: Cisco MDS 9500 Series switches running Cisco MDS SAN-OS Release 2.0(2b) or later support the SSM module.

The SSI image for the SSM is downloaded from the supervisor module. The image for an SSM can be specified using the SSI boot variable.

Note Note: The SSM can operate as a 32-port Fibre Channel switching module with the standard Cisco SAN-OS images for Release 2.1(2) or later. You need the SSI image if you use intelligent storage services.

The following table lists the features supported for the SSM :

Module Cisco MDS SAN-OS Release
2.0(1b) 2.0(2b), 2.0(3), 2.0(4), and 2.0(4a) 2.1(1a) 2.1(2) and later
SSM None Fibre Channel switching Fibre Channel switching Fibre Channel switching
Intelligent Storage Services Intelligent Storage Services Intelligent Storage Services
VSFN VSFN Nondisruptive upgrade for Fibre Channel switching traffic1

When you upgrade, or downgrade, the SSI boot image on an SSM, you might disrupt traffic through the module. The following table describes how updating the SSI boot image affects SSM traffic.

Cisco MDS SAN-OS Release Traffic Type Disrupts Traffic?

2.0(2b) through 2.1(1a)

All

Yes

2.1(2) and later

Layer 2 Fibre Channel switching only

No1

Both Layer 2 Fibre Channel switching and Layer 3 Intelligent Storage Services (such as FCWA, NASB, SANTap, and ISAPI virtualization)

Yes

Layer 3 Intelligent Storage Services (such as FCWA, NASB, SANTap, ISAPI virtualization) only

Yes

Initial Troubleshooting Checklist

Common Troubleshooting Tools in Fabric Manager

Common Troubleshooting Commands in the CLI

SSM Issues

SSM Fails to Boot

Upgrading the SSI Image

Verifying the SSI Boot Image

Using the install ssi Command

Recovering a Replacement SSM

SSM Upgrade Is Disruptive

Installing EPLD Images on Modules


Back to Main Page: Cisco MDS SAN-OS Troubleshooting Guide

Rating: 0.0/5 (0 votes cast)

Personal tools