Application Extension Platform 1.x -- Configuring the Router
Configuring the Router
To configure the Cisco Integrated Services Router, perform the following steps.
Option 1 Connect to the router by opening a telnet session from the terminal window on a PC running Windows OS. Then go to to the next step -- Connect to the Cisco Integrated Services Router using Telnet
Option 2 Use secure shell (SSH) -- for example by using client emulation software PuTTY. Then go to step Enter your username and password
Connect to the Cisco Integrated Services Router using Telnet
Enter your username and password
telnet 192.168.1.39 Trying 192.168.1.39 ... Open ..... User Access Verification Username: cisco Password: cisco 2800_w_axp#
Check the Mode
In the example above, the # sign shows that you are in privileged EXEC mode.
If you see a > symbol instead of the # symbol as the prompt, enter the
enable command, followed by your password to enable the Cisco ISR.
Verify the Running Configuration
To check the running configuration enter the following command:
interface GigabitEthernet0/0 ip address 10.7.0.90 255.255.255.0 shutdown duplex auto speed auto media-type rj45 ! interface GigabitEthernet0/1 ip address 172.16.10.1 255.255.255.0 duplex auto speed auto media-type rj45 ! interface Integrated-Service-Engine4/0 ip unnumbered GigabitEthernet0/1 service-module ip address 172.16.10.2 255.255.255.0 !Application: Online on NME service-module ip default-gateway 172.16.10.190 no keepalive !
Tip: Press the space bar to scroll through the output if the entire configuration is not visible on your screen.
The running configuration shows multiple interfaces, for example: eth0, eth1, and Integrated-Service-Engine1/0 (ISE1/0). The number of interfaces depends on the model of router and the number of installed service modules. For links to hardware documentation, refer to the relevant Release Notes.
Show the Interfaces
show interfaces shows all the interfaces.
show interfaces interface_name shows only the specified interface.
2800_w_axp# show interfaces 2800_w_axp# show interfaces eth0 2800_w_axp# show interfaces eth1 2800_w_axp# show interfaces Integrated-Service-Engine 1/0
Tip: To scroll through the output, press the space bar repeatedly.
For further information on configuring Cisco routers, refer to links in the Platform-Specific Documents section in the Cisco AXP Release Notes
Return to start of Getting Started Guide: Cisco AXP Getting Started Guide