Application Extension Platform 1.x -- Configuring the Router

From DocWiki

(Difference between revisions)
Jump to: navigation, search

Revision as of 02:46, 17 November 2010

Contents

Configuring the Router

To configure the Cisco Integrated Services Router, perform the following steps.

Connect

Option 1 Connect to the router by opening a telnet session from the terminal window on a PC running Windows OS. Then go to to the next step -- Connect to the Cisco Integrated Services Router using Telnet

Option 2 Use secure shell (SSH) -- for example by using client emulation software PuTTY. Then go to step Enter your username and password

Connect to the Cisco Integrated Services Router using Telnet

telnet ip-address

Enter your username and password

Username: username

Password: password

Example:

telnet 192.168.1.39  
 
Trying 192.168.1.39 ... Open

.....

User Access Verification

Username: cisco 

Password: cisco 

2800_w_axp#

Check the Mode

In the example above, the # sign shows that you are in privileged EXEC mode. If you see a > symbol instead of the # symbol as the prompt, enter the enable command, followed by your password to enable the Cisco ISR.


Verify the Running Configuration

To check the running configuration enter the following command:

#show running-config

Example:

interface GigabitEthernet0/0
 ip address 10.7.0.90 255.255.255.0
 shutdown
 duplex auto
 speed auto
 media-type rj45
!
interface GigabitEthernet0/1
 ip address 172.16.10.1 255.255.255.0
 duplex auto
 speed auto
 media-type rj45
!
interface Integrated-Service-Engine4/0
 ip unnumbered GigabitEthernet0/1
 service-module ip address 172.16.10.2 255.255.255.0
 !Application: Online on NME
 service-module ip default-gateway 172.16.10.190
 no keepalive
!

Tip: Press the space bar to scroll through the output if the entire configuration is not visible on your screen.


The running configuration shows multiple interfaces, for example: eth0, eth1, and Integrated-Service-Engine1/0 (ISE1/0). The number of interfaces depends on the model of router and the number of installed service modules. For links to hardware documentation, refer to the relevant Release Notes.

Show the Interfaces

show interfaces shows all the interfaces.
show interfaces interface_name shows only the specified interface.

Example:

2800_w_axp# show interfaces

2800_w_axp# show interfaces eth0 

2800_w_axp# show interfaces eth1 

2800_w_axp# show interfaces Integrated-Service-Engine 1/0 

Tip: To scroll through the output, press the space bar repeatedly.

Additional References

For further information on configuring Cisco routers, refer to links in the Platform-Specific Documents section in the Cisco AXP Release Notes


Return to start of Getting Started Guide: Cisco AXP Getting Started Guide

Rating: 0.0/5 (0 votes cast)

Personal tools